ICS Cool Energy has launched a new range of thermal mass cycling refrigeration air dryers specifically designed for the treatment of compressed air systems.
ICS Cool Energy has launched a new range of thermal mass cycling refrigeration air dryers specifically designed for the treatment of compressed air systems.
The new DE-ETM range is an extension of ICS Cool Energy’s compressed air and gas system, and is suitable for applications that require low energy consumption, reliability and high performance even when operating for long periods of time.
It provides the treatment of a high compressed air flow for a wide range of demands, from 32 to 225m3/min.
The DE-ETM thermal mass technology is Eurovent A-rated, and uses R410a refrigerant, said to allow the units to adapt energy consumption to the actual load, therefore achieving significant savings compared to other dryers on the market.
In addition, the range’s aluminium heat exchanger also minimises pressure drops.
The special bar and plate technology of heat exchangers ensures that DE-ETM works with high compressed air flow while maintaining a precise DEW point (to control and measure the amount of water vapour in the compressed air), during all conditions and low pressure drops.
You might also like...
‘Clean cold’ congress closes with demand for systemic cooling rethink
Event warns over lack of skills for adopting lower GWP gas and the need for a broader approach to cooling where decarbonisation is viewed as just one vital part of wholesale industry rethink
Samsung commits to R32 expansion following ‘wind-free’ AC launch
New air conditioner technology designed to curb reliance on direct air flow is intended to be made available for use with R32 from later this year
Heineken to set itself stiffer carbon reduction targets
Brewing giant announces ‘Drop the C’ programme, which will see reduced carbon in cooling alongside major expansion in use of renewable energy
RAC Magazine February digital issue out now
AC industry facing up to uncertainty of F-Gas cuts on refrigerant supply
Have your say
You must sign in to make a comment
Please remember that the submission of any material is governed by our Terms and Conditions and by submitting material you confirm your agreement to these Terms and Conditions.
Links may be included in your comments but HTML is not permitted.